Spring is in the air and the planting season is drawing nearer. For this project we utilized the rotary attachment to engrave clay flower pots we painted ourselves. These personalized pots are perfect for any gardener or plant-lover.
We used a 45-watt Helix with the following settings: 40% speed, 100% power.
The first step is spray paint your pots. It is extremely important to apply even coats of paint to the pots. If your layers are uneven, the laser may get through some and not others, leaving a spotty engraving behind.
After your pots are evenly painted and thoroughly dry, follow these steps:
Open either sc_clay_blue.cdr or sc_clay_purple.cdr.
Change text as necessary.
Insert the rotary attachment into the machine.
Place the pot securely on the attachment and adjust for size.
The project is ready to go - run it with suggested speeds and powers for your wattage of laser.
中国、中国澳门、广州、北京和中国香港： East Systems Technology, LTD. Daniel Chow Rm A2, 25/Fl, Block 1, Tai Ping Industrial Centre 57 Ting Kok Road Tai Po, N.T., Hong Kong 852-31561139 Phone 852-81004530 Fax Email: Send a message More Information