Thanksgiving is just around the corner! Here we laser engrave and cut adorable place card holders for your Thanksgiving table. Turkeys and cornucopias compliment the crisp fall colors and greet your guests with a festive welcome to your holiday table.
This project is a great way to bring a little organization to this fun, but often hectic, holiday.
We used a 35-watt Zing 16 with the following settings:
Raster speed: 100%, Raster power: 10%.
Vector speed: 100%, Vector power: 20%
Begin by printing the names of your guests on the light paper. We used a calligraphy-style font printed brick red on cream colored paper. Cut the name cards so they are approximate 3.25" wide by 3" inches long.
Now you're ready to engrave the place card holders. Open the file and place the paper into the machine. Since we're using such a thin material and a Zing 16, we'll need to manually focus the laser.
Adhering the placecards. Simply tape the nametags to the back of the place card holder with the name facing outward and you're done! You may also use lightweight paper glue if you prefer not to use tape.
中国、中国澳门、广州、北京和中国香港： East Systems Technology, LTD. Daniel Chow Rm A2, 25/Fl, Block 1, Tai Ping Industrial Centre 57 Ting Kok Road Tai Po, N.T., Hong Kong 852-31561139 Phone 852-81004530 Fax Email: Send a message More Information